Hot glue the felt circle to the top of the 2″ foam circle and long rectangle felt around the edge. Trace a 2″ circle and 1″x7″ rectangle on the felt with a crayon. Glue the extra fleece on the back side like you’re giftwrapping a present.
Stuff the foam rectangle into the fleece and stretch the corners until you get a nice fit. Repeat the glue, align and cut off steps for each of the four corners of fleece until you start to get a box shape. Be careful not to press directly on the fleece with your fingers, since the glue will seep through the fleece.Ĭut off the excess fleece. Use a yardstick or large ruler to draw straight lines along each edge of the foam on the fleece.įold the fleece over so the longer line aligns with the glue on the short line. You can use scissors on the foam, but the knife cuts easier.Ĭut out a 8.5″x12.5″ rectangle of gray fleece. Cut both out carefully with an X-Acto Knife. Trace the 3″x5″ rectangle and 2″ circle on the foam with a Sharpie. Don’t Push the Button! Red Button Activity PDF.“Don’t Push the Button” book by Bill Cotter.So what could make a button pushing book even better? How about a soft and cuddly button you can push? And the results are unexpected for each additional push.
When he can’t resist the temptation any longer, he tells the reader to push the button. You just keep tapping down on the shifter and it will go from neutral to reverse.įYI I did this on my 01 450s as well as an 05 500 foreman S.Don’t Push the Button! by Bill Cotter is an interactive children’s picture book featuring Larry and a large red button that he shouldn’t push. Once this is done you DO NOT have to touch the reverse button or touch the brake lever. Once you reach the point it bypasses the reverse lock the shifter will go into reverse without touching the reverse button and/or brake lever. You should feel the shifter getting tighter. Keep adjusting it out while tapping down on the shifter (going into reverse). Turn the adjusting sleeve out, so you are seeing more of the thread. Loosen the locking nut (I believe it took a 9mm open ended wrench). If you find the adjusting sleeve located on cable 3 in this exploded diagram: It will be the one with a nut that locks the adjusting sleeve in place. HOW TO DISSABLE THE REVERSE BUTTON-BRAKE ON S MODEL HONDA ATVĪllows you to shift into reverse without pushing red reverse button and pulling left brake lever.
0 kommentar(er)
